Command: conLine
Description:
Constructs a line and shows the line parameters. The command refers to
the fundamental line processor that is used whenever a line is to be
constructed. The line can be constrained to orthogonal mode only. The
supported construction methods are
- Pick: The line is constructed by picking an existing
line.
- 2 Points: The line is constructed from two
points P1 and
P2.
- Point and vector: The line is constructed from a
point P and a
vector v.
- Point and circle: The line is constructed from a
point P
tangential to a circle
c. One of the up to two possible lines must
be identified by picking.
- 2 circles: The line is constructed tangential to two
circles c1 and
c2. One of the up to four possible lines
must be identified by picking.
